Saudi Arabia has no shortage of water treatment companies. The Saudi Water Authority’s public register of licensed water and wastewater operators runs to dozens of entities, and many more firms sell equipment, chemicals and packaged plants. For an industrial site, the harder question is which kind of company you need. In Saudi Arabia that depends less on the brand than on where your treated water, brine and sludge will go, and which authority signs off on it.
This guide does not rank companies. It shows how the Saudi rules shape the choice, which public registers you can check a provider against, and where independent advice on brine and zero liquid discharge (ZLD) is worth paying for. For the general picture of provider types (chemical suppliers, equipment makers, contractors, operators and consultants) and how each is paid, see our guide to industrial water treatment companies. This page covers what is specific to the Kingdom; for the UAE and the wider Gulf, see our Middle East overview.
Brine Consulting is an independent industrial water advisory firm in Amsterdam. We sell no treatment equipment, so nothing in this guide steers you towards one Saudi vendor’s technology over another’s.
Start with the authority that will sign off your discharge
The authority that will sign off your discharge depends on the industrial city your site sits in and where the water ends up, and the same factory effluent can fall under different rules in each case. Settle this before you invite bids, because it fixes the treatment target every bidder has to price. Getting it wrong is more than a design problem: the aqueous media regulation carries its own violations and penalties table, which MEWA amended in September 2024.
| Your situation | Who sets the rules | What it means for the provider you choose |
|---|---|---|
| Treated wastewater discharged to the environment from a site outside the Royal Commission cities | The National Center for Environmental Compliance (NCEC), under the Executive Regulation for the Protection of Aqueous Media from Pollution, which MEWA began applying in July 2021 | A licence or permit is needed to discharge treated wastewater to the environment. The regulation sets treated wastewater standards and standards for outfalls and mixing zones, and tasks NCEC with setting controls for injecting water into ground wells and for dewatering. Ask bidders to guarantee performance against your permit values, not a vague “meets local standards” line. |
| Jubail, Yanbu, Ras Al-Khair or Jazan City for Primary and Downstream Industries | The Royal Commission for Jubail and Yanbu (RCJY), under the Royal Commission Environmental Regulations, RCER-2015 | RCER has its own Environmental Permit to Construct and Permit to Operate. In the 2015 edition, effluent sent to a central treatment plant had to meet a pretreatment standard (Table 3B) and direct discharge to coastal waters a separate table (3C). The Royal Commission has since notified operators of an updated edition, RCER-2025, so confirm with RCJY which edition and tables apply to your permit before design. A vendor whose references are all outside the Royal Commission cities should show it has designed to these tables. |
| A factory in a MODON industrial city that discharges to the city network | MODON (the Saudi Authority for Industrial Cities and Technology Zones) and the operator of the city’s treatment plant | Your target is the city’s connection conditions, which may call for pretreatment rather than a full discharge-quality plant. Some city plants run under long private contracts: the one at Jeddah 1st Industrial City was awarded on a 25-year rehabilitate, operate and transfer basis, with treated water sold for industrial use. Get the conditions in writing before anything is sized. |
| You buy treated water or a wastewater service from a third party | The Saudi Water Authority (SWA), which replaced the Saline Water Conversion Corporation (SWCC) in May 2024 and sets licensing standards for the sector | Check that the operator holds the SWA licence for the service it is selling (see the next section). |
| Your client is a government entity | The Local Content and Government Procurement Authority (LCGPA), under the Government Tenders and Procurement Law | Government buyers generally follow LCGPA’s mandatory list of national products, and a list covering water treatment chemicals took effect in March 2022. Ask every bidder how its offer meets these rules. |
If a site falls under two rows, for example a plant inside a Royal Commission city that also sends a brine stream off site, put both sets of conditions in the request for proposals.
Three public checks before you shortlist anyone
1. The SWA licensed entities register. SWA publishes a register of licensed entities showing what each one is licensed to do: desalinated water production, wastewater treatment, wastewater collection and transport, trading in wastewater, and treated water transport and distribution, among others. It matters when a provider will own or run a plant and sell you water or a wastewater service. What it does not tell you is whether the firm can handle your effluent. A licence to run a municipal sewage plant says little about a high-salinity stream from a petrochemical or mining site. Ask instead for reference plants treating water like yours that have run for at least a year.
2. NCEC’s licensed environmental service providers. NCEC licenses environmental service providers, including consultancies that prepare environmental permit applications, audits and periodic environmental reports. Several engineering firms, among them Mott MacDonald and Egis, have announced NCEC “Class A” consultancy licences. NCEC reported 760 licensed providers in May 2026. Whoever prepares your permit documents should hold this licence. That is a different job from process design for the treatment plant. Many projects need both, and both should work from the same site water balance.
3. Local content evidence, if the state is a buyer. SWA’s mandate includes unifying technical and engineering standards across the water sector, including local content requirements. For any project where a government or state-linked body is paying, ask for the bidder’s local content position in writing.
Be careful with “top 10 water treatment companies in Saudi Arabia” lists. Some are published by vendors that put themselves first and state no method for the ranking.
Brine and ZLD: settle the endpoint before you ask for a ZLD price
ZLD removes every liquid discharge by concentrating brine until only solids remain. It is usually the most energy-intensive and costly way to deal with saline wastewater, so the first question is not “which ZLD supplier?” but “which liquid routes do we actually have, and what would each cost?”
Geography shapes the answer. A coastal site may have a permitted outfall to the Gulf or the Red Sea, subject to NCEC’s outfall and mixing-zone rules or, inside the Royal Commission cities, the RCER coastal discharge limits. An inland plant has no sea. Its options are a sewer or industrial city connection whose conditions can accept the salt load, an injection route (NCEC sets the controls for injecting water into ground wells, so confirm the approval route with NCEC early), a reduced-volume discharge (minimal liquid discharge, or MLD), or concentrating the brine to a solid. Each route has its own approval and its own cost. Price them side by side before ZLD becomes the default. Much regulated activity is inland: of the more than 4,300 environmental permits NCEC reported in a quarterly update published in May 2026, more than 1,700 were in the Riyadh region.
Our brine disposal cost guide sets out what drives the price of each route. Three free tools help with the first pass:
the MLD vs ZLD Decision Screener flags whether ZLD, MLD or reuse deserves a closer look, and where the disposal route is still unresolved;
the Brine Mass Balance Calculator works out concentrate flow, concentration and loads for a treatment step at a given recovery;
our guide to ZLD feasibility studies explains what a study should settle before anyone quotes for equipment.
Saudi Arabia produces more than 11.1 million cubic metres of desalinated water a day, which SWA describes as the largest output of any country (SWA website, checked November 2026). At that scale, desalination brine is a resource question as much as a disposal one: SWA offers a mineral extraction service for companies interested in recovering magnesium, calcium, sodium chloride, bromine, lithium, potassium and sulfate from it. Plants inside Jubail Industrial City work under RCJY rules rather than NCEC’s, as the table above shows.
What to put in a Saudi request for proposals
Most of a good request for proposals is the same anywhere: flows, a full and checked water analysis, the treatment target and site limits. Our ZLD vendor proposal checklist covers those. In Saudi Arabia, add:
The regulatory route from the table above, with the permit or connection document and its limit values attached.
Who holds and files the permit: your company, the plant operator, or an NCEC-licensed consultant acting for you.
The source of the feed water. Seawater, brackish groundwater and network water give very different salt loads, and the salt load sets the brine volume.
Who takes the residues: the brine, salt and sludge, where they go, and who pays for transport and disposal.
A performance guarantee written against the permit limits, with the test duration and the remedy if the plant falls short.
Licence and local content evidence, where the earlier checks apply.
Check the water analysis before it goes out. Our Water Analysis Validator calculates the charge-balance error and compares the ion sum with reported TDS, so gaps in the lab data show up before a bidder designs around them.
When is an independent ZLD consultant worth hiring on a Saudi project?
An independent consultant works for the plant owner and is not paid by the equipment order. On a Saudi project that usually means the technical basis behind the permit and the tender: the site water balance, a review of the effluent data, screening of MLD, ZLD and reuse options, a technology-neutral specification, and a like-for-like comparison of the bids that come back. Filing the permit itself sits with an NCEC-licensed environmental consultancy, and building and guaranteeing the plant sits with the contractor or supplier.
We take on that owner’s-side technical role for Saudi sites from Amsterdam, remotely or as a scoped engagement, so that the three decisions above (which discharge route to permit, whether ZLD is needed at all, which bid is really the cheaper one) rest on a checked water balance rather than on a vendor’s proposal. Your NCEC-licensed consultant files the permit and the contractor builds; we work from your data and drawings alongside both. On Saudi projects that work covers saline wastewater, brine management, MLD and ZLD, industrial water reuse and resource recovery from brine. Our expert network includes two former SWCC desalination specialists (SWCC is now the Saudi Water Authority), as well as specialists in brine crystallization and industrial wastewater process engineering. See our water treatment and ZLD consulting service.
Do the NCEC rules apply to a plant in Jubail?
Not for permits and discharge limits. Inside the Royal Commission cities, RCJY’s own environmental regulations (RCER) set the permits and the discharge and pretreatment limits your plant is designed to. The 2015 edition is being superseded by RCER-2025, so ask RCJY which edition applies to your permit and put those tables in your request for proposals. Our guide to industrial wastewater treatment in Jubail explains which RCER tables apply and what Marafiq charges.
Talk to us before you go to tender
If you are deciding whether a Saudi site needs ZLD at all, or you have bids written to different NCEC or RCER assumptions and cannot compare them, send us the water analysis and the permit or connection conditions. Book a call with Christos Charisiadis, send us your project details or email christos@brineconsulting.com.
Written by the Brine Consulting advisory team. The Brine Consulting advisory practice includes Dr. A. Mohammed Farooque, a senior desalination and membrane technology expert who spent 29 years at Saudi Arabia’s Saline Water Conversion Corporation (SWCC), now the Saudi Water Authority, where he headed the Seawater Reverse Osmosis Research Group, and Osis G. Kalache, P.Eng., a senior wastewater process engineer with more than 17 years in industrial wastewater treatment and process optimization. Meet our experts.